top of page
Close-up of a custom powder-coated wheel rim with an intricate design, featuring a vibrant orange and white color scheme

POWDERCOATED PROJECTS

Masking Project

This was a project that one of the collaborators did in there shop for a customer. Full white first, partial bake. Mask with high heat tape and vinyl. Partial bake, remove masking, full cure.

IMG_2924_edited.jpg

Powdercoat on porcelain 

Porcelain toilets powdercoated. Cleaned powdercoated as separate units and then assembled.

IMG_2551_edited.jpg

Race car chassis

This is a close up shot of a sprint car chassis. New chassis clean, bake off in the oven, apply powder when the part is at room temperature, bake the part.

IMG_5214.JPG

Powercoat with hydrodip

A collaborator purchased a truck and wanted to make it different by adding something to it that is not done on a regular basis, possibly never. Chrome bumpers were removed and cleaned. Clear powder partially baked. Hyrdodipped on the clear powder. Another coat of clear powder. Final bake.

IMG_3010_edited.jpg

Brake Caliper Powdercoat

This project required disassembly of the caliper. A good washing is the key because of the silicone based fluid. Powdercoat, bake and reassemble.

IMG_4355_edited.jpg

Powdercoated Glass

This is a close up of a translucent purple powder applied to a wine glass. The masking was vinyl. Clean glass, apply the vinyl, bake the part at a low temp, remove the vinyl when the part cools, final bake the part. Clean off any glue from the vinyl then run it through a dish washer.

IMG_1213_edited_edited.jpg
bottom of page